Gres de Aragon Cerámica 2024

274 RECOMENDACIONES PARA LA COLOCACIÓN DE REJILLA CERÁMICA PORCELÁNICA PORCELAIN CERAMIC GRID LAYOUT RECOMMENDATIONS • The ceramic grid is designed to have an enough breaking load for pedestrian traffic, however, to have full performance, it should only be placed in the direction recommended by Gres Aragón. • The grid pieces must not be joined together, the space between the pieces is also a surface for the evacuation of water. • Due the hard and rigid nature of the ceramic, the seat of the grid pieces must be as smooth and uniform as possible, without roughness and be perfectly clean for proper support. • If the support is cement material, one of every three or four pieces can be fixed to limit its possible displacement with cement glue, with an injection gun, in the parallel slits of the reverse of the piece. • If the support is ceramic, it is recommended to put in the slot an Oring of EPDM with a diameter of 5 mm, to prevent its movement. • In any case, it is recommended to place them on the Acepool B-33 system of GRES ARAGÓN for an optimal result. • For a correct execution, so for the rigid grid as well as for the flexible grid, the recommendation is to use the plastic connector supplied that keeps the space between pieces and their alignment. • The flexible grids are prepared to be placed with a minimum radius of 0.82 meters. • La rejilla cerámica está diseñada para tener una carga de rotura suficiente para el tránsito peatonal, no obstante, para disponer de plenas prestaciones, únicamente se debe colocar en el sentido que recomienda Gres Aragón. • Las piezas de rejilla no se rejuntan entre sí, el espacio entre piezas también es superficie para el desalojo de agua. • Dado el carácter duro y rígido de la cerámica, el asiento de las piezas de rejilla debe ser lo más liso y uniforme posible, sin rugosidades y estar perfectamente limpio para un correcto apoyo. • Si el apoyo es sobre material cementoso, se puede fijar una de cada tres o cuatro piezas para limitar su posible desplazamiento con cemento cola, con una pistola de inyección, en las hendiduras paralelas del reverso de la pieza. • Si el soporte es cerámico, se recomienda poner en la ranura una junta tórica de EPDM de diámetro 5 mm, para evitar su movimiento. • En cualquier caso, se recomienda colocarlas sobre el sistema Acepool B-33 de GRES ARAGÓN para un óptimo resultado. • Para una correcta ejecución, tanto para la rejilla rígida como para la rejilla flexible, se recomienda utilizar el conector plástico suministrado, mantiene el espacio entre piezas y el alineado de las mismas. • Las rejillas flexibles, están preparadas para colocarlas con un radio mínimo de 0,82 metros.

RkJQdWJsaXNoZXIy NzM4MzM=